Allied Telesis AT-iMG6x6MOD Electronics Unit - Manual (Page 27)

AT-iMG646MOD Installation Guide
Chapter 4: Installing the Gateway Indoors 27
Connecting the Coax Cable (if applicable)
With the HPNA card, the AT-iMG646MOD allows PCs, Set Top Boxes, VCRs, etc. to become members of
an ethernet subnet over the coax network that is already installed. Figure 20 shows an example of how the
devices could be configured. The coax-to-ethernet converter can be purchased as ATI Part Number AT-
iMG007.
Figure 20. Coax Network Configuration
To connect the coax cable, perform the following procedure:
1. Connect the coax cable to the HPNA card, as shown in Figure 21
.
Figure 21. Connecting the Coax cable
AT-iMG646MOD
as Master
Splitters are passive with
4-20 GHz range
Coax 25 to 35m
Coax 3 to 5m
1:4 Splitter
1:2 Splitters
Coax to ethernet
converter
1:2 Splitters
1:2 Splitters
network_physical_coax.ai