Allied Telesis AT-iMG6x6MOD Electronics Unit - Manual (Page 19)

Chapter 4: Installing the Gateway Indoors 19
Chapter 4
Installing the Gateway Indoors
This chapter describes how to install the gateway in an indoor location.
Warning
This unit is intended for installation in a restricted access location. A restricted access location in
where access can only be gained by authorized service personnel through the use of a special tool, lock
and key, or other means of security, and is controlled by the authority responsible for that location.
Required Tools and Supplies
Tools
Have the following tools on hand before you install the enclosure or gateway:
ˆ Flat head and #2 Phillips screwdrivers
ˆ Wire cutters
ˆ Crimping tool
Additional Supplies
You may also need the following supplies:
ˆ Silicone sealant
ˆ Electrical tape
ˆ Two wire ties
ˆ Console cable
ˆ
Power cable (AT-iMG646MOD-C01)
ˆ
Power supply (AT-iMG005G/AT-iMG006G)
ˆ
Fiber cleaning materials (see Appendix B, “Cleaning Fiber Optic Connectors” on page 39)
ˆ
Plywood mounting surface (see “Fastening the Plywood Mounting Surface to a Wall” on page 21 for
specifications)
ˆ Accessory kit for indoor installation