Blodgett BPBB SERIES - Manual (Page 10)

P/N 3000012219 REV. A Page 10
INSTALLATION CODES and STANDARDS
Installation of Phoenix series appliances must comply with all local and national building
codes for gas and electrical installations. Refer to standards ANSI Z233.1-1988 and
ANSI/NFPA 70-1990 or later for specifications. All installation or service work should be
performed by qualified personnel. (See explanation of qualified personnel at the
beginning of this manual).
ELECTRICAL INSTALLATION (convection models only)
WARNING: Electrical and grounding connections must comply with applicable
portions of the NATIONAL ELECTRICAL CODE ANSI/NFPA-70 (latest edition) and
local code requirements.
WARNING: The range must be electrically grounded in accordance with the
NATIONAL ELECTRICAL CODE and local code requirements.
For convection ovens, provide an electrical outlet capable of supplying 115 volts 60HZ 1
Phase for 1/4 HP blower motor. Blower motor amp draw is 4.4 amps/8 amp surge.
WARNING: This appliance is equipped with a three prong (grounding) plug for
user protection against shock hazard and should be plugged directly into a
properly grounded three prong receptacle. Do not cut or remove the grounding
prong from the plug.
CLEARANCES FROM COMBUSTABLE MATERIALS
Side Rear Floor
With 6" legs or 5" caters installed 4"
(10.16 cm)
2"
(5.08 cm)
6"
(15.24 cm)
Without 6" legs or 5" casters installed 4"
(10.16 cm)
2"
(5.08 cm)
0"
( 0 cm)
CAUTION: When appliance is installed without legs or casters, it must be set on a non-
combustible curb or platform with a minimum front projection of 4 1/2" over the curb or
platform. Leveling bolts (5/8-11) can be used in the bottom frame of the range. If
plumbing and electrical connections allow, standard oven units can be installed flush to a
NON-COMBUSTABLE rear wall.
NOTE: Convection models are NOT recommended for curb or platform installations.
These models also require minimum 2” clearance at rear of unit