Blodgett BPBB SERIES - Manual (Page 22)

P/N 3000012219 REV. A Page 22
Convection models
Grease should not be allowed to build-up on fan blower, also the vent openings of the
motor (located in the rear) must be kept clean using a stiff bristle brush and/or vacuum
Open Top Section
DAILY: Allow surfaces to cool and wipe top with burlap or other grease absorbing
material to remove spills and grease before they burn on.
WEEKLY: Allow surfaces to cool and wash open top section with a solution of washing
soda and water. Remove and wash drip pan under burners. Brush burner head with a
stiff wire brush. Clean clogged ports with a stiff wire or ice pick. Remove excessive
grease build up from burners by soaking in a solution of washing soda. Dry burners by
inverting them on an oven rack at a low temperature.
NOTE: Make sure the air shutters remain intact and in the same position as when the
burners were removed from the appliance.
Hot Top / French Top Section
DAILY: Allow surfaces to cool and wipe top with heavy burlap or steel wool and rub
briskly until clean. In order to clean all flanges and under lid, lift rings and plates.
WARNING: Never pour water on a HOT French Top/Hot Top section as water can
splash and/or intense steam can cause severe burns.
Griddle Section
DAILY: During use, scrape surface with the flat edge of spatula or metal scraper to
remove encrusted material. Wipe frequently with heavy absorbent cloth. Allow surface to
cool and polish with soft griddle stone or a high-grade grill pad. The griddle may be
washed with a cleanser and warm water, which will not crack the steel plate.
WARNING: Never pour water on a HOT griddle as water can splash and/or intense
steam can cause severe burns.
To oil the griddle, use a hydrogenated shortening. Never use salad oils, margarine or
butter, which cannot withstand temperatures greater than 300ºF.
Service
When service is required, contact your local Blodgett Authorized service company. To
find a Blodgett Authorized service company, go to www.blodgett.com and click on
service locator. You may also contact your dealer or the factory to perform mechanical
maintenance and repair. All mechanical maintenance procedures can be found in the