Blodgett BPBB SERIES - Manual (Page 13)

P/N 3000012219 REV. A Page 13
Top Burner Adjustment
1.
Remove top burner control knobs.
2. Remove front manifold cover plate
3. Loosen the screw on the air shutter.
4. Light the burners and observe the quality of the flame. Flame should be
sharp, well defined, two-tone blue as shown in Figure 7 (A).
5. Adjust the air shutter as required.
6. Tighten screw on the air shutter.
7. Repeat procedure for all remaining burners.
8. Replace burner knob
9. Replace front manifold cover plate
NOTE: When using LP (liquid petroleum/propane) the flame may have a slight yellow tip,
however the yellow tip should be no greater than 10% the overall flame size as shown in
Figure 7 (B).
Figure 9: Top Burner Air Shutter Adjustment