Blodgett BPBB SERIES - Manual (Page 8)

P/N 3000012219 REV. A Page 8
CAUTION: This restraining device must always be in place when the appliance is in use.
If it is to be removed for cleaning purposes or to service the appliance, it must be re-
installed before the appliance is put back into service. Per ANSI regulations Z-21.69
(connectors), Z-83.11 (commercial gas ranges), Z-21.41 (quick-disconnect devices), with
latest revisions.
RESTRAINING DEVICE INSTALLATION
Figure 3: Restraining Device
(Must be installed when casters are used)
INSTRUCTIONS
This is a separate cable and should be less than 6" away from the gas connector in a
parallel orientation.
1. Adjust cable clamps (1) so that cable length is 3" to 6" shorter than the
length of the gas connector including fittings.
2. Secure eyelet plate to structurally sound attachment such as wall stud or
other solid attachment point.
3. Attach the scissor hook to the staple and secure with cotter pin.
4. Attach the spring hook to the gas appliance.
5. ** Check to make certain that the overall length of the restraining device is 3"
to 6" shorter than the overall length of the gas connector.
WARNING: Eyelet cable and all connections to wall and appliance must be
strong and secure enough to prevent appliance movement from pulling on gas
fitting in any way when the appliance is moved.