Blodgett BPBB SERIES - Manual (Page 19)

P/N 3000012219 REV. A Page 19
Convection Oven Re-Igniter (electronic ignition)
NOTE: In order for the re-Igniter to operate, the master (power) switch located at the top
of the oven panel must be in the ON position.
If the pilot light is extinguished by drafts or temporary loss of gas pressure from air in
lines, the re-igniter will immediately attempt to re-light the pilot.
If the pilot fails to light, the thermocouple will cool (usually within 30 seconds) and shut
the gas off to the burner. This will require that the pilot light be re-lit manually.
Turn the oven gas valve to the OFF position. Wait 5 minutes. Then repeat steps 1-10
above to re-light pilot.
CONVECTION OVEN OPERATION
WARNING: The oven and its parts are hot. Use care when operating, cleaning, or
servicing the appliance.
1. Turn on the master power switch.
2. Turn the oven gas valve to ON.
3. Set thermostat to the desired temperature.
4. Turn fan switch to AUTO. (This will turn on the fan.)
5. Allow oven to pre-heat to the desired temperature. (12-16 minutes.)
6. Open oven door. (Fan will automatically stop.)
7. Place product into oven leaving space all around for even heating.
8. Close oven door. (Fan will turn on and oven will begin baking.)
NOTE: Placing the fan switch to MANUAL will allow the fan to run when the oven door is
opened to rapidly lower the oven temperature.
Convection Oven Controls
OVEN
THERMOSTAT
OVEN GAS
CONTROL
POWER
SWITCH
POWER ON
LIGHT
BLOWER
AUTO-MANUAL
SWITCH