Nikon 24mm-f-35D-PC-E-Nikkor - Manual (Page 26)

En
26
b Set the tilt and shift knobs. (Fig. 3)
Note: Turning either knob too tightly may damage the
knob.
Fig. 3
c Turn the camera power off,
align the mounting indexes on
the lens and camera and then
twist the lens counterclockwise
until it locks into place. (Fig. 4)
• Mounting the lens to a
camera while camera’s power
is on, may prevent the camera
from operating correctly.
5. Using bayonet hood HB-41
Align the lens hood attachment index
(
) on the hood (either of two
indexes) with the lens hood mounting
index on the lens, and turn the hood
clockwise until it click stops to secure.
• Make sure that the lens hood
mounting index aligns with the lens
hood setting index (
).
• If the lens hood is not correctly
attached, vignetting can occur.
• To facilitate attachment or removal of the hood,
hold it by its base around the lens hood
attachment index rather than its outer edge.
• To store the lens hood, attach it in the reverse position.
Fig. 5
Fig. 4