Nikon S800c - Manual (Page 139)

E 23
Transferring Images to Your Smart Device
Re
fe
re
n
ce
S
ec
ti
o
n
B
Notes About Simple Setup
• The simple setup function is not able to connect the COOLPIX S800c to multiple smart devices.
The simple setup function can connect the camera to only one smart device.
• When you use the simple setup function to configure a new connection to a smart device other
than the one that was previously configured, the previous connection settings are overwritten
with the new ones. To use the previous connection settings, perform the simple setup procedure
again.
• To reconfigure the previous connection settings when using an iOS4.x smart device, uninstall the
previously installed camera profile before performing the simple setup procedure again.
Transferring Images from Camera to Smart Device
1
Tap Start service on the camera screen.
2
Tap Connect to camera on the smart device
screen.
• The smart device initiates a connection with the camera
using the settings you previously made, and the
Searching... screen is displayed.
• If the “Activate Wi-Fi and select the camera SSID.” message is
displayed when you are using an iOS smart device, follow the
procedure below to configure the settings.
- Make sure the smart device’s Wi-Fi (wireless LAN)
function is on. If the Wi-Fi (wireless LAN) function is off,
turn it on.
- In the network list displayed on the smart device when the
smart device’s Wi-Fi (wireless LAN) function is turned on, select the network SSID that is
displayed on the camera screen.
After the settings are complete, display the Connect to S800c application screen
again.
Simple setup
Start service
Upload to smart device
15:30
Simple setup
Connect to camera
Connect to S800c
15:30