Nikon S800c - Manual (Page 36)

14
Ba
si
c
St
e
ps
f
o
r
Sh
oot
in
g
an
d
Pla
yb
ac
k
1
Prepare the included Charging AC Adapter EH-69P.
If a plug adapter* is included with your camera, attach the plug
adapter to the plug on the Charging AC Adapter. Push the plug
adapter firmly until it is securely held in place. Once the two are
connected, attempting to forcibly remove the plug adapter could
damage the product.
* The shape of the plug adapter varies depending on the country or
region in which the camera was purchased.
The Charging AC Adapter comes with the plug adapter attached
in Argentina and Korea.
2
Make sure the battery is installed in the camera, and then connect the
camera to the Charging AC Adapter in the order indicated by the
numbers in the illustration below.
• Keep the camera turned off.
• Be sure that plugs are properly oriented. Do not attempt to insert plugs at an angle,
and do not use force when connecting or disconnecting the plugs.
• The power-on lamp slowly flashes orange to indicate that the battery is charging.
• About 4 hours are required to charge a fully exhausted battery.
• When the battery is fully charged, the power-on lamp stops flashing and turns off.
• See “Understanding the Power-on Lamp” (A15) for more information.
3
Disconnect the Charging AC Adapter from the electrical outlet, and
then disconnect the USB cable.
• When the camera is connected to an electrical outlet with the Charging AC Adapter,
the camera cannot be turned on.
Preparation 2 Charge the Battery
USB cable (included)
Electrical outlet
Power-on lamp