Nikon WT-4A D4 D3X D3 D800 D700 D300S D300 - Manual (Page 106)

94
PC Mode
/
C
o
n
tr
o
ll
in
g t
h
e Ca
me
ra
Using the WT-4 with a Computer
Controlling the Camera
1
Complete the steps in “Connecting to the Computer” (pp. 90–
93).
2
Start Camera Control Pro 2 on the host
computer and confirm that “PC” is
displayed in the camera control panel.
3
Control the camera as described in the Camera Control Pro 2
manual. Any photographs taken while the camera is
connected will be recorded directly to the computer hard disk.
4
Turn the WT-4 off when transfer is
complete. Wait for the POWER LED (pg.
3) to turn from green to yellow and
then go out, and then disconnect the
USB cable.
D
Wireless Networks
More time may be required to complete operations on wireless networks.
D
Ethernet Networks: Do Not Disconnect the Ethernet Cable
Do not disconnect the Ethernet cable while the camera is on.
A
Wireless Networks: Loss of Signal During Transfer
A loss of signal may interrupt the connection while pictures are being
transferred to Camera Control Pro 2. If the POWER LED on the WT-4 is
blinking (pg. 2), turn the WT-4 off and then on again. Transfer will resume
when the connection is re-established. Do not turn the camera off.
Transfer can not be resumed once the camera has been turned off.