Nikon WT-4A D4 D3X D3 D800 D700 D300S D300 - Manual (Page 20)

8
Pr
ep
ari
n
g
th
e W
T-
4
Introduction
Preparing the WT-4
Attach the Antenna
Attach the supplied antenna to the WT-4 as
shown in the diagram.
Inserting the Battery
To prevent loss of power during setup or upload, use a fully-
charged battery or an optional AC adapter. The WT-4 takes one
EN-EL3e rechargeable Li-ion battery; other batteries can not be
used. Note that the drain on the battery is increased when the
WT-4 is attached.
1
Open the battery chamber cover.
2
Using the side of the battery to
push the battery latch to one
side, slide the battery in until
the latch clicks into place. Be
sure the battery is in the
correct orientation. For safety
precautions and information
on charging the battery, see the battery and charger manuals. Battery latch