Nikon LS-3500 - LS-3510 User Manual
Page 19
Software Installation - Macintosh
1-3
Software Reference for Scanners
Fig. 2
NB Handler control panel
Check to see that the addresses are correctly entered and conform to the
factory default settings of the device DIP switches. If so, proceed to the next
section, Using The Macintosh Plugin Scanning Module.
If you wish to change the configuration, use the rename button to change any
devx setting to the appropriate name of the device. Set the address in the text-edit
box labeled
Primary
. It is not necessary to restart your machine for the changes to
take effect. Simply close the Control Panel and go on to Getting Started.
>Note
If you have an older NB Handler Init installed it may not be of the control
panel type and will not show up in your Control Panels folder. If so, you can
use the IBCONF utility usually supplied with your National Instruments NB-
GPIB board to add the Nikon configuration to your old Init, or you can
modify the new one with the control panel shown above to include your other
devices, such as film recorders and other scanners.