Nikon LS-3500 - LS-3510 - Manual (Page 29)

Getting Started On The IBM 4-1
Software Reference for Scanners
Getting Started on the IBM
Launching the Application
Launch PhotoStyler by double clicking the appropriate icon.
Pull down the File menu to reach the Scan... menu item and select Nikon
Scanner Control... from the hierarchical menu. The main scanning dialog will
appear as below and the Device : and Address : lines should indicate that there is a
scanner connected. If the dialog appears as below, you are ready to start scanning
and can proceed to Scanning a Preview Image.
Fig. 14 Main Scanning Dialog
If the message in the upper left-hand corner reads “ Nikon LS-3510AF Ver
1.xx ” on either a SCSI or GPIB interface, you are ready to make a preview or
scan. If not, the plugin has not found the scanner and you will need to check your
SCSI or GPIB cabling, confirm tight connections and proper termination. For
SCSI installations with other external devices, place the scanner at the end of the
chain with the standard supplied terminator for your machine. If you are unsure
what GPIB or SCSI address to use, consult the Setup Guide included with your
scanner.