A.J. Antunes & Co VCT-2000 9210212 - Manual (Page 12)

VERTICAL CONTACT TOASTER
12 P/N 1010875 Rev. C 02/13
Daily
CLEANING THE BLACK AND SILVER RELEASE SHEET,
CONVEYOR BELT WRAPS, AND TOASTER
Tools Required:
• Heat-resistant gloves
• Clean towels
• Multipurpose Detergent Solution
• Sanitizer Solution
1. Turn the Rocker Switch off, unplug the power
cord, and allow the unit to cool for 30 minutes.
2. Put on heat-resistant gloves. Remove the Bun
Feeder, Heat Shield, and Bun Chute (Figure 1).
Wipe them with a damp sanitized towel and allow
them to air dry.
3. Remove the Release Sheet and place it on a
clean, flat dry surface. Wipe the silver side with
a clean towel dampened with Multipurpose
Detergent Solution immediately followed by a
second clean towel dampened with sanitizer and
allow it to air dry before continuing. Repeat this
step on the black side of the Release Sheet once
the silver side is dry.
4. Open the front Conveyor Cover and firmly wipe
the black Belt Wrap from left to right and top
to bottom with a clean towel dampened with
Multipurpose Detergent Solution immediately
followed by a second clean towel dampened with
sanitizer.
5. Close the front Conveyor Cover, open the rear
Conveyor Cover, and clean the Belt Wrap as
described in Step 4.
MAINTENANCE
WARNING
Turn the power off, unplug the power cord, and
allow the unit to cool down 30 minutes before per-
forming any service or maintenance.
CAUTION
To prevent damage to the unit, do not use abra-
sive cleaners on the Release Sheet or Belt Wrap.
CAUTION
Failure to use Release Sheets may result in dam-
age to the unit and loss of warranty coverage.
6. Close the rear Conveyor Cover and reinstall the
Heat Shield. Then plug in the power cord, turn the
power on, count 10 seconds, turn the power off
and unplug the power cord.
7. Open the rear Conveyor Cover again, clean the
newly exposed section of the Belt Wrap in the
same manner as before. Close the Conveyor
Cover.
8. Open the front Conveyor Cover again and clean
the newly exposed section of the Belt Wrap in the
same manner as before.
9. Close the front Conveyor Cover and wipe down
the outside of the toaster with a clean, damp,
sanitized towel.
10. Install the Release Sheet by draping it over both
sides of the Platen with the crease centered on
the Platen.
NOTE: Rotate the Release Sheet from the black
side to the silver side daily or weekly to prolong
the life of the Release Sheet.
11. Install the Bun Chute so the hooks are installed
over the lower Support Rod. Install the Heat
Shield with the Release Sheet Retainer clips
securely over the Release Sheet and Platen.
12. Reinstall the Bun Feeder and plug the power cord
into the appropriate outlet.
NOTE: Make sure the Heat Shield is activating the
Conveyor Safety Interlock Switch. The conveyors
will not rotate unless the Heat Shield is in place
and the Conveyor Safety Interlock Switch is acti-
vated.
NOTE: Check the Release Sheet to make sure it
is not caught in the Conveyor. Additional Release
Sheets can be obtained through your Authorized
Service Agency under P/N 7000249 (3 Pack) or
7000250 (10 Pack).