A.J. Antunes & Co VCT-2000 9210212 - Manual (Page 8)

VERTICAL CONTACT TOASTER
8 P/N 1010875 Rev. C 02/13
NOTE: The toaster is tested and shipped with the heaters
set at the above recommended temperatures.
OPERATION
Figure 3. Bun Thickness Adjustment Controls
Operating Instructions
1. Set the Bun Thickness Adjustment Controls
(Figure 3) to desired setting.
NOTE: Recommended settings are #2 for heel and
#6 for crown.
2. Turn the Rocker Switch on. (Figure 2). Allow the
toaster to warm up for 30 minutes.
NOTE: The temperature display (Figure 2) will flash
“LO” until the toaster reaches its preset operating
temperature. When the toaster approaches the pre-
set temperature of 600°F (315°C), “USE” appears
in the temperature display and the unit is ready to
toast buns. If “USE” does not appear in the window
after a warm-up period of approximately 30 min-
utes, contact your Authorized Service Agency.
3. Drop Crowns and Heels into the slot (Figure 2).
Cut sides of heel and crown must face each
other.
4. Toasted buns will drop into the bun landing area
(Figure 2) in approximately 10 seconds.
5. Test at least four buns before putting the toaster
into service.
6. Turn the Rocker Switch off when finished toasting
for the day and proceed with the Daily Cleaning
as outlined in the Maintenance section of this
manual.
Temperature Adjustments
The VCT-2000 uses a Platen Heater and two Auxiliary
Air Heaters. The Platen Heater consists of a heating
element built into the Platen to toast the cut side of the
bun. The two Auxiliary Heaters assist in providing addi-
tional heat to the buns. The first Auxiliary Air Heater is
located between the conveyor in the front of the toast-
er. The second Auxiliary Heater is located between the
conveyor at the rear of the unit.
RECOMMENDED TEMPERATURES
Recommended temperature setting for the Platen
Heater is 600°F (315°C).
Recommended temperature setting for the Auxiliary Air
Heaters is 400°F (204°C).
1
2
4
5 1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
3 = 11/16"(17.5mm)
6 = 7/8"(22.2mm)
THICKNESS THICKNESS
1
2
3
4
6
6
5
4 = 3/4"(19.1mm) 5 = 13/16"(20.6mm)
3
Bun Thickness
Adjustment Control
(Figure 3)
Bun Landing Area Rocker
Switch
Temperature
Controls
& Temperature
Display
Hi-Limit
Reset
Power
Cord
Figure 2. VCT-2000 Toaster
THICKNESS THICKNESS
4
3
2
5
6
1 D
C
B
E
F
A
2 = 3/4" (19mm)
3 = 13/16" (21mm)
4 = 7/8" (22mm)
5 = 15/16" (24mm)
6 = 1" (25mm)
1 = 5/8" (16mm)
B = 7/8" (22mm)
F = 1 1/8" (29mm)
D = 1" (25mm)
E = 1 1/16" (27mm)
C = 15/16" (24mm)
A = 3/4" (19mm)