A.J. Antunes & Co VCT-2000 9210212 - Manual (Page 15)

15
VERTICAL CONTACT TOASTER
P/N 1010875 Rev. C 02/13
Weld
Screws
Acorn Nuts
Spacers
Tensioner
Assy.
Tape
Figure 14. Replacing Roller Tensioner Assy.
Figure 13. Measuring Roller Tensioner Assy.
REPLACING ROLLER TENSIONERS
1. Remove the Acorn Nuts and old Roller Tensioner
Assembly (Figure 14).
2. Replace with the new Roller Tensioner Assembly,
and reassemble.
3. Make sure the spacers are placed inside the
tensioner arm. The spacers are smaller than the
holes to allow the tensioner to pivot freely.
MAINTENANCE (continued)
Roller Tensioners (Every 3 to 6 months)
MEASURING ROLLER TENSIONERS
1. Measure the Roller Tensioner on both inner
Conveyor Covers (Figure 13). The space between
the inner Conveyor Cover and bottom of the ten-
sioner wheel should be 13/16” (2.1 cm) or the
height of a U.S. Nickel. Adjust or replace any
damaged ones as recommended.