HID ProxPro Installation Guide - Manual (Page 3)

ProxPro
®
Installation Guide Part No. 5355-900, Rev N.1
1 System Overview
The ProxPro® reader is a self-contained proximity reader. The two-piece polycarbonate enclosure has
an rubber Gasket that seals the pieces together and a cable fitting that seals the cable entry. The water
resistant unit is approved for outdoor use. The enclosure is designed to fit on a single gang electrical
box. A Bi-color LED and audible tone enhance user feedback. A tamper switch feature is available that
will alert the Host when the enclosure is opened. An internal DIP switch makes the configuration of the
outputs, audible tone, keypad and LED control options simple.
Installation of the ProxPro reader consists of mounting, verifying the DIP switch settings, setting a
tuning jumper and connecting the cable to the Host.
1.1 Operation
Access Cards may be presented to either the front or the back of the reader. Optimum read range is
achieved when the access card is presented face on, and parallel to the reader face. The LED is
normally controlled by the internal reader firmware. Alternatively, the LED can be controlled by the
access control host panel. When the LED is controlled directly by the reader, the LED normal state is
red, and indicates that the reader is ready to read an access card. The LED turns green when the
access card is read and the message is transmitted to the Host system. When the reader is ready for
another access card, the LED returns to red. The typical time the LED is green is 250 milliseconds .
The reader only controls the green state of the LED, there is no amber LED state. The operation of the
LED may be controlled by the Host. When the LED is host system controlled, the LED and beeper
operation may vary depending on the particular host software. The LED may then exhibit a red, green
or “amber” color for certain status conditions as controlled by that host’s software.
1.2 Parts List
1 ProxPro Reader qty 1 (included)
2 #6-32 x 1 self tapping screws, Type T or 23 qty 2 (included)
3 Installation Manual qty 1 (included)
4 Cable Fitting qty 1 (included)
5 Cable, 5 conductor, 22awg
(Alpha 1295 C or equivalent) as required (max. 500 feet)
See cable notes
6 Cable, 20 conductor, 22awg
(Alpha 1299/20C or equivalent) as required (max. 500 feet)
See cable notes
7 DC Power Supply 12V/100mA or 24V/120mA 1 (Installer supplied)
8 Recommended power supply in the E.U. is the Micro State Electronics Model PS-5
February 22, 2007 Page 3 of 14
© 2007 HID Global Corporation. All rights reserved.