4 switch configuration, 1 switch 1-1 hardware identity, Switch configuration – HID ProxPro Installation Guide User Manual
Page 6: Switch 1-1 hardware identity, Dimension drawing (actual size)
Advertising
Part No. 5355-900, Rev N.1 ProxPro
®
Installation Guide
4 Switch Configuration
5.00" (127mm)
3.28" (83.3mm)
5.00" (127mm)
1.00" (25.4mm)
O
O
O
O
O
O
O
O
O
O
TB1
2 - GND
3 - DATA "0"
4 - DATA "1"
5 - DATA RTN
1 - DC +
TAMPER SW
SW1
P1
P2
mounting holes (2 places)
Dimension Drawing (Actual Size)
7 - Red LED
6 - Green LED
8 - Beeper
9 - Hold
1 - n/o
3 - n/c
10 - COM
O 11 - Tamper
123
Figure 1 DIP Switch Settings - Switch 1
4.1
Switch 1-1 Hardware Identity
When set in the "on" position the unit is configured for "Wiegand" interface. The "off" position
configures the unit for "Clock-and-data" interface.
Page 6 of 14
February 22, 2007
© 2007 HID Global Corporation. All rights reserved.
Advertising