Information – Alpine TME-M710 User Manual

Page 10

Advertising
background image

9

-EN

In Case of Difficulty

If you encounter a problem, please review the items in
the following checklist. This guide will help you isolate
the problem if the unit is at fault. Otherwise, make sure
the rest of your system is properly connected or consult
your authorized Alpine dealer.

No function or display.

• Car's ignition is off.

- Turn the ignition on.

• No fuse or blown fuse.

- Check the cause and replace the fuse.

• Incorrect connections.

- Check connection and remedy.

• Vehicle's battery is weak.

- Check the voltage of vehicle's battery.

Unclear picture display.

• Fluorescent tube is exhausted.

- Replace the fluorescent tube*.

No picture display.

• Brightness control is set for minimum brightness control.

- Adjust the brightness.

• Incorrect setting of the VTR mode.

- Switch to the correct mode.

• Protective circuit is on because of high temperature.

- Wait until the temperature inside the vehicle comes

down to the operating temperature range (45

°C).

• Incorrect or open connection with the Monitor, AV

interface unit.

- Check the connection and remedy.

Picture color is poor.

• Brightness/Color/Tint control are not set to the proper

positions.

- Check each control.

Spots or dotted lines/stripes appear.

• Caused by neon signs, high-voltage power lines, CB

transmitter, other vehicle's ignition plugs, etc.

- Change the location of your vehicle.

Unit does not operate.

• Monitor's power is not turned on.

- Turn on the monitor's power.

Information

Navigation screen is not displayed or navigation

system’s remote controller keys do not work.

• Navigation system’s power is turned off.

- Press the ON/OFF (POWER) button on the navigation

system’s remote controller to turn the navigation
system’s power on.

Screen is out of position.

• Navigation system is connected by using the RCA

extension cable.

- Press and hold the DISP button for at least 2 seconds to

switch the screen position.

* The fluorescent tube replacement is not free of charge

even within the warranty period, for the tube is an article
of consumption.

Advertising