Alpine TME-M710 - Manual (Page 15)

14
-EN
Attaching the monitor and stand (for
European customers only)
• For customers in other countries:
The stand is not included.
CAUTION
Do not install the monitor near the front
passenger seat air bag system.
1
Remove the main unit attachment fitting.
2
Loosen the main unit attachment fitting with a coin
etc., slide it into the track on the rear of the main
unit and temporarily fasten it. Then fix it to the
stand.
3
Check the sticking position.
1 Temporarily fasten the stand with gum tape.
2 Loosen the adjustment screws, and adjust to a
safe, viewable position.
Main unit
attachment fitting
Pull this part to release.
Slide in an upward
direction.
In order to use safely, attach to the following
places.
• Stable and secure places.
• Places that will not have your view blocked by
the main unit when driving.
• Places that you will not hit against if you lean
forward while you wearing your seatbelt.
• Places where the main unit cannot hit against
the steering wheel while driving.
• Be aware that if the surface of the dashboard is leather, wooden
panel, stretched fabric or any non-resin based product, then the
surface will be damaged when you remove the stand.
• Do not place the main unit directly in front of the air conditioner
vents.
The fixed arm tilts towards the
seat side.
If the main unit
invades your line of
sight then it will
block your view. Dashboard
Line of sight
Main unit
Front glass side Seat side
Angle
adjustment
screw
Installation and Connections