Alpine TME-M710 - Manual (Page 18)

17
-EN
1 Parking brake lead (Yellow/Blue)
Connect this lead to the parking brake lead
powered when parking brake is pulled.
2 Dimmer lead (White/Blue)
This lead may be connected to the vehicle’s
instrument cluster illumination lead. This will
allow the backlighting of the unit to dim whenever
the vehicle’s lights are turned on.
34Remote control output lead (White/Brown)
To remote control input lead of ALPINE products
used in the system.
5 Reverse Lead (Orange/White)
Use only when a back-up camera is connected.
Connect to the plus side of the car’s reverse
lamp that lights when the transmission is shifted
into reverse (R).
Switches the video picture to the back-up
camera. This is linked with putting the car into
reverse (R).
6 ACC power lead (Red)
To ACC power lead powered when engine key
position is ACC.
7 Fuse (7.5A)
8 Ground lead (Black)
Connect the lead to a good chassis ground on
the vehicle. Make sure the connection is made to
bare metal and is securely fastened using the
sheet metal screw provided.
9 Parking Brake Lamp
p Brake Connector (Included)
q Parking Brake Signal Lead
w Parking Brake Switch
e Headphone
r Main monitor
t Connection cable
If the cable is too short, use the extension cable
(KWE-664N, sold separately).
y RGB cable
u To RGB output terminal
i Made by Alpine navigation
o Audio input connectors (AUX 1)
Use these connectors to input the audio signals
from a DVD player, video deck etc.
; Video input connector (AUX 1)
Use this connector to input the video signals
from a DVD player, video deck etc.
a Audio input connectors (AUX 2)
Use these connectors to input the audio signals
from a DVD player, video deck etc.
s Video input connectors (AUX 2)
Use this connector to input the video signals
from a DVD player, video deck etc.
• When connecting a rear view camera, use the “AUX
IN 2”.
To prevent external noise from entering the
audio system.
• Locate the unit and route the leads at least
10 cm away from the car harness.
• Keep the battery power leads as far away from
other leads as possible.
• Connect the ground lead securely to a bare
metal spot (remove the coating if necessary)
of the car chassis.
• If you add an optional noise suppressor,
connect it as far away from the unit as
possible. Your Alpine dealer carries various
Alpine noise suppressors, contact them for
further information.
• Your Alpine dealer knows best about noise
prevention measures so consult your dealer for
further information.