Alpine TME-S370 - Manual (Page 14)

12
-EN
Adjusting the Minimum Level of
Backlight (Dimmer Low Level)
Min (0) to Max (16) (Default Setting: Min)
If Low is set in “Setting the Brightness of the
Backlighting (Dimmer)” (page 11), you can adjust the
brightness of the backlighting. This function can be
used, for instance, to change the screen brightness
while traveling at night.
Changing the Base Color
Blue / Green / Red / Amber
Select your favorite base color. The default color is blue.
See navigation owner's manual to synchronize the base
color of navigation system (NVE-M300 only). Check "Sync
with Head Unit Color" under Display Setting.
Beep Function
On (Default Setting) / Off
On: Activates the beep when the button is pressed.
Off: Deactivates the beep. The beep will not be
produced when a button on the unit is pressed.
Adjusting the Touch Panel (Screen
Alignment)
You must adjust the touch panel when the display
position on the LCD and the touch position on the
touch panel do not match.
1
Touch [ ].
The adjustment screen appears.
Screen Adjustment
2
Press and hold the center of [ ] mark
accurately and follow [ ] mark as
appeared on the screen.
When the adjustment is completed, the Display
Setup Mode screen is displayed.
AUX Setup Operations
Adjusts the AUX display setting. Refer to page
14 for details.
Returns to the factory default settings of
AUX setup. The message, "Restore default
settings?" appears. Touch "Restore" to go
back to the default settings.
Source Name
Aux / DVD / DVD-HU / DVB-T / iPod / TV / Sirius TV
Select the name from the following list, to be used
for the product using the AUX input mode. This will
apply to the button name on Source Select screen
and the source name in title bar on AUX screen.
Setting the TV System
Auto / NTSC / PAL
The TV/Video system can be manually switched.
Setting the Video Signal
Composite / S-Video
The Video Signal selection menu is only available
in AUX source. AUX must be connected with either
Composite cable or S-Video cable. You cannot
connect both cables at the same time. It may cause
noise on the screen. Refer to System Connection
(Page 20).
Changing Sound Output (DVD-HU Vol. Control)
Off / On
Off: Outputs sound through the built-in speakers. The
volume indicator is displayed.
On: The built-in speaker is mute and head unit volume
is adjustable from TME-S370 touch volume control.
The volume indicator is not displayed. In order to
control DVD-HU volume, make sure remote wire is
connected to DVD head unit.
290533_TME370_r13.indb E12 290533_TME370_r13.indb E12 7/29/09 1:29:15 PM 7/29/09 1:29:15 PM