Alpine TME-S370 - Manual (Page 5)

3
-EN
PRECAUTIONS
Product Cleaning
Use a soft dry cloth for periodic cleaning of the
product. For more severe stains, please dampen the
cloth with water only. Anything else has the chance of
dissolving the paint or damaging the plastic.
Temperature
Be sure the temperature inside the vehicle is between
+45°C (+113°F) and 0°C (+32°F) before turning your
unit on.
Maintenance
If you have problems, do not attempt to repair the unit
yourself. Return it to your Alpine dealer or the nearest
Alpine Service Station for servicing.
Installation Location
Make sure the TME-S370 will not be installed in a
location subjected to:
• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations
• After turning the system off, a slight ghost of the
image will remain temporarily. This is an effect
peculiar to LCD technology and is normal.
• In cold temperature conditions, the screen may lose
contrast temporarily. After a short warm-up period, it
will return to normal.
Operation of some of the functions of this unit is very
complex. Because of this, it was deemed necessary to
place these functions into a special screen. This will
restrict operation of these functions to times when
the vehicle is parked. This ensures the focus of the
driver’s attention will be on the road and not on the
TME-S370.
This has been done for the safety of the driver and
passengers. The setup operation cannot be made if the
car is moving. The car must be parked and the parking
brake must be engaged for the procedure described
in the Owner’s Manual to be valid. The warning
“Operation is not allowed while driving,” will be
displayed if any attempts are made to perform these
operations while driving.
290533_TME370_r13.indb E3 290533_TME370_r13.indb E3 7/29/09 1:29:12 PM 7/29/09 1:29:12 PM