Sony RM-AX4000 - Manual (Page 104)

Updating the Remote Commander's firmware
You can update the Remote Commander's firmw are to the one compatible w ith the version of AX Remote Editor.
Note
If you update the firmw are, all the current settings of the Remote Commander are deleted. So proceed w ith caution, being careful not to delete necessary data.
1. Conne ct the Re m ote Com m ande r (RM -AX4000) to your PC w ith the USB m ini cable .
Note s
o Do not disconnect the USB mini cable from your PC until dow nloading is complete, otherw ise a malfunction may occur.
o Only connect one Remote Commander to your PC at a time. Otherw ise, you w on't be able to dow nload the settings correctly.
2. Click "Tools " on the m e nu bar, the n s e le ct "Update Firm w are for Re m ote ."
A confirmation dialog box appears.
Note s
If the version of AX Remote Editor is older than the firmw are version of the Remote Commander, a message box appears asking you to update AX
Remote Editor. In this case, after checking the firmw are version of the Remote Commander, dow nload the compatible version of AX Remote Editor from
the w ebsite.
3. Click "Ye s ."
AX Remote Editor starts dow nload the update file. When dow nloading is complete, a message box appears.
Note s
o If "The Remote Commander is not connected or not responding." appears, the Remote Commander (RM-AX4000) may not be connected to your PC
properly. After checking the connection, click "Retry" to repeat the operation.
o If "Cannot perform the operation because the system cannot open the file." appears, reinstall AX Remote Editor.
4. Click "OK."
The message box closes.
Page 104