Sony RM-AX4000 - Manual (Page 9)

Connecting the Remote Commander to your PC
You can connect the Remote Commander (RM-AX4000) to your PC w ith the supplied USB mini cable. When you check the remote control signal of a macro
(Action list) programmed for a key/button, or w hen you exchange setting data betw een your PC and the Remote Commander, connect the Remote Commander
to your PC.
IM PORTANT
 Do not keep the Remote Commander connected to the PC w hen the PC is in standby/hibernation, otherw ise, a malfunction could occur. Be sure to
disconnect the Remote Commander from the PC before standby/hibernation begins.
 Furthermore, do not connect the Remote Commander to the PC w hile it is in standby/hibernation. Wait until the PC comes out of standby/hibernation before
connecting.
Note s
 The Remote Commander uses the battery w hen connected to the PC. When you finish the setup, unplug from the USB connector.
 Before connecting the Remote Commander to your PC, make sure that the battery charge is enough.
 Do not disconnect the USB mini cable from your PC w hile your PC is communicating w ith the Remote Commander, otherw ise a malfunction may occur.
 Only connect one Remote Commander to your PC at a time. Otherw ise, your PC w on't be able to communicate w ith the Remote Commander.
1. Conne ct the USB m ini cable to the USB conne ctor of the Re m ote Com m ande r (RM -AX4000).
2. Conne ct the USB m ini cable to the USB conne ctor of your PC.
Note
The first time you connect the Remote Commander (RM-AX4000) to your PC, the USB driver install w izard appears. For further installation details, refer to the
supplied operating instructions.
Page 9