American Megatrends MegaRAID Express 500 - Manual (Page 100)

MegaRAID Express 500 Hardware Guide 86
68-Pin SCSI Connector Pinout, Continued
High-Density Single Ended Connector The following applies to the high-density SCSI connector
table on the previous page:
•
A hyphen before a signal name indicates that signal is active low.
•
The connector pin refers to the conductor position when using 0.025 inch
centerline flat ribbon cable with a high-density connector
(AMPLIMITE.050 Series connectors).
•
Eight-bit devices connected to the P-Cable must leave the following signals
open: -DB (8), -DB (9), -DB (10), -DB (11), -DB(12), -DB (13), -DB (14), -
DB 15), and -DB (P1).
•
All other signals should be connected as defined.
Caution
Lines labeled RESERVED should be connected to Ground
in the bus terminator assemblies or in the end devices on the
SCSI cable.
RESERVED lines should be open in the other SCSI
devices, but can be connected to Ground.