American Megatrends MegaRAID Express 500 - Manual (Page 70)

MegaRAID Express 500 Hardware Guide 56
Step 5 Set Jumpers
Make sure the jumper settings on the MegaRAID Express 500 card are correct.
The jumpers and connectors are:
Connector Description Type
J1 SCSI bus termination enable control 3-pin header
J2 CPLD programming 10-pin header
J3 NVRAM clear 2-pin header
J4 Serial EPROM 2-pin header
J5 Serial port 3-pin header
J6 Write Pending 2-pin header
J7 BIOS enable 2-pin header
J8 User activity LED 4-pin connector
J9 I2C connector 4-pin header
J10 SCSI bus termination power 2-pin header
J11 Internal straddle-mount connector 68-pin connector
J13 External SCSI connector 68-pin connector
J15 Rub1 slot interrupt steering 3-pin header
J16 Rub1 slot interrupt steering 3-pin header
J17 Rub1 slot interrupt steering 3-pin header
MegaRAID Express 500 Card Layout
Cont’d