Sony LBT-LCD77Di - Manual (Page 109)

MHC-GZR333i/LBT-LCD77Di.GB.4-181-572-11(1)
10 GB
Additional I
nf
or
ma
tion
The iPod does not function.
 Make sure the iPod is connected
securely.
 Make sure the iPod is updated with the
latest software. If not, update the iPod
before using with the system.
 Because the operation of the system
and the iPod are different, you may not
operate the iPod using buttons on the
remote or unit. In this case, use control
buttons on the iPod.
The iPod cannot be charged.
 Make sure the iPod is connected
securely.
 You can use the system as a battery
charger for iPod only when the system
is on.
Video/photo image from the iPod
does not appear on the TV screen.
 Make sure the iPod is connected
securely.
 Set the operating mode to the iPod
Display mode to display photo images
(page 66).
 Check that the TV output setting on
the iPod is on. (Refer to the user’s
guide of your iPod.)
 Check that the iPod is compatible with
video output. (Refer to the user’s guide
of your iPod.)
Video/photo image from the iPod
does not appear on the iPod display.
 Make sure the iPod is connected
securely.
 Adjust the video/photo image output
settings to the appropriate settings.
On screen display does not appear on
the TV screen.
 Make sure the iPod is connected
securely.
 Check that the operating mode is set to
the Main Display mode (page 66).
USB device
You cannot start transferring or
recording to a USB device.
 The following problems may have
occurred.
 The USB device is full.
 The number of files and folders on
the USB device has reached the
upper limit.
 The USB device is write-protected.
Transferring or recording is stopped
before it is finished.
 You are using an unsupported USB
device. See “Compatible devices
with this system” (page 126) for the
supported device types.
 The USB device is not formatted
correctly. Refer to the operating
instructions supplied with the USB
device for how to format.
 Turn off the system and remove the
USB device. If the USB device has a
power switch, turn the USB device
off and then on again after removing
it from the system. Then perform
transferring or recording again.
Continued
