Sony LBT-LCD77Di - Manual (Page 30)

MHC-GZR333i/LBT-LCD77Di.GB.4-181-572-11(1)
0 GB
7
Press  or  repeatedly to select
the desired setting, then press
ENTER.
The default setting is underlined.
 OFF: Outputs interlace signals.
Select this setting when:
 your TV does not accept
progressive signals.
 your TV is connected to jacks
other than the COMPONENT
VIDEO OUT jacks.
 ON: Outputs progressive signals.
Select this setting when:
 your TV accepts progressive
signals.
 your TV is connected to the
COMPONENT VIDEO OUT
jacks.
When you select “ON,” the
confirmation display appears. Follow
the steps below.
8
Press  or  repeatedly to select
“START,” then press ENTER.
The system outputs the progressive
signal for 5 seconds. Check that the
screen is displayed correctly.
9
Press  or  repeatedly to select
“YES.”
The system outputs the progressive
signal. When you select “NO,”
the system does not output the
progressive signal.
Note
There would be no image on your TV or the
image is not clear if your setting does not
match your TV or connection.