Sony STR-DN1040 - Manual (Page 42)

42 US
What is WPS (Wi-Fi
Protected Setup)?
WPS is a standard created by the Wi-Fi
Alliance allowing you to setup a wireless
network easily and securely.
Setting up a wireless
network using the WPS push
button configuration
method
You can easily set up a WPS wireless
connection with one push of the designated
button.
1 Select “WPS Push” in step 6 in
“Searching for an access point and
setting up a wireless network
(Access Point Scan method)”
(page 40).
2 Follow the on-screen instructions,
and press the WPS button on the
access point.
Message: “Push the WPS button on the
access point within 2 minutes.”
“Network Settings are now complete
and the receiver has been successfully
connected to the network.” appears after
the network settings are complete and
“
” lights up on the display panel. To
return to the Network Settings menu,
press .
(Depending on the network
environment, the network settings may
take some time.)
3 Perform the server settings.
To listen to audio content stored on the
server, you need to set up your server
(page 61).
When checking the network settings, see
“Information” (page 101).
Setting up a wireless
network using the WPS PIN
code method
If the access point supports the WPS PIN
(Personal Identification Number) code
connection, you can set up a WPS wireless
connection by entering the receiver’s PIN
code into the wireless LAN router/access
point.
1 Select “Manual Registration” in step
6 in “Searching for an access point
and setting up a wireless network
(Access Point Scan method)”
(page 40).
2 Press V/v repeatedly to select “WPS
PIN”, then press .
The available SSID (access point) list
appears.
SSID that does not support WPS PIN will
appear dimmed and cannot be selected.
3 Press V/v repeatedly to select the
network name (SSID) you want, then
press
.
The PIN code (8 digits) of the receiver
appears on the TV screen. Leave the PIN
code displayed until the connection is
complete. (A different PIN code is
displayed each time you perform this
operation.)
4 Input the receiver’s PIN code into the
wireless LAN router/access point.
The receiver starts the network settings.
“Network Settings are now complete
and the receiver has been successfully
connected to the network.” appears after
the network settings are complete and
“ ” lights up on the display panel. To
return to the Network Settings menu,
press
.
(Depending on the network
environment, the network settings may
take some time.)
Tip
WPS button on the
wireless LAN
router/access point
Note