Sony PCV-J200 - Manual (Page 42)

VAIO® System Reference Manual 30
8 If necessary, remove any add-in cards (see “Removing an Add-in
Card” on page 27) to gain access to the battery. You may also need to
disconnect some cables.
9
Use a flathead screwdriver to push in on the small tab inside the
battery holder to pop out the battery.
10
Use your fingers to lift out the battery, and dispose of it according to
the instructions that came with the new battery.
11
Insert the new battery into the battery holder, with the plus (+) side
up, and gently press down until the battery snaps into place.
12 Replace any add-in cards that were removed.
13 Reconnect any cables that were disconnected.
14 Replace the side panel (see “Replacing the Side Panel” on page 25).
15
Reconnect the power cord, and turn on the computer.
!
Touch any exposed metal part of chassis to discharge static electricity in
your body before handling an add-in card or other sensitive electronic
component.
✍
The battery is located just beneath the hard drive holder. Although you do not have to
remove the hard drive holder, this illustration shows the battery with the drive holder
removed for clarity.
✍
The Sony CR2032 battery is recommended. Using a type of battery other than a
CR2032 may present a risk of fire or explosion.