Sony PCV-J200 - Manual (Page 88)

VAIO® System Reference Manual 76
PCI Configuration Status and Error Messages
The following is a list of status and error messages that may appear on
your system.
Message Meaning
Floppy Disk Controller
Resource Conflict The floppy disk controller has requested a
resource that is already in use.
CMOS Checksum Error,
CMOS Cleared The CMOS data was reinitialized due to a
CMOS checksum error.
CMOS Data Invalid,
CMOS Cleared Invalid entry in the CMOS.
Parallel Port Resource
Conflict The parallel port has requested a resource that is
already in use.
PCI Error Log is Full This message is displayed when more than 15
PCI conflict errors are detected. No additional
PCI errors can be logged.
PCI I/O Port Conflict Two devices requested the same resource,
resulting in a conflict.
PCI IRQ Conflict Two devices requested the same resource,
resulting in a conflict.
PCI Memory Conflict Two devices requested the same resource,
resulting in a conflict.
Primary Boot Device Not
Found The designated primary boot device (hard disk
drive, floppy disk drive, CD-ROM drive, or
network drive) could not be found.
Primary IDE Controller
Resource Conflict The primary IDE controller has requested a
resource that is already in use.
Primary Input Device Not
Found The designated primary input device
(keyboard, mouse, or other, if input is
redirected) could not be found.
Primary Output Device
Not Found The designated primary output device (display,
serial port, or other, if input is redirected) could
not be found.
Secondary IDE Controller
Resource Conflict The secondary IDE controller has requested a
resource that is already in use.
Serial Port 1 Resource
Conflict Serial port 1 has requested a resource that is
already in use.
Static Device Resource
Conflict A device has requested a resource that is already
in use.
System Board Device
Resource Conflict A device has requested a resource that is already
in use.