Sony SDM-E76D - Manual (Page 30)

6
(GB)
Setup
Before using your monitor, check that the following items are
included in your carton:
• LCD display
• Power cord
• HD15-HD15 video signal cable (analog RGB)
• DVI-D video signal cable (digital RGB)
(SDM-E76D/SDM-E96D only)
• Cord strap
• CD-ROM (utility software for Windows/Macintosh, Operating
Instructions, etc.)
• Warranty card
• Quick Setup Guide
Step 1: Use the stand
x Use the supplied stand
Open the stand.
Note
The stand is folded at the factory. Be sure not to place the display
vertically with the stand as it is. Otherwise, the display may topple over.
x Use the VESA compatible stand
When using a non-supplied VESA compatible mounting arm or
stand, use the VESA compatible screws to attach.
You can use the display with or without the supplied stand.
Step 2: Connect the display to your
computer
Turn off the monitor and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this might
bend the pins.
• Check the alignment of the HD15 connector to prevent bending the pins
of the video signal cable connector.
x Connect a computer equipped with a DVI
output connector (digital RGB)
(SDM-E76D/SDM-E96D only)
Using the supplied DVI-D video signal cable (digital RGB), connect the
computer to the monitor’s DVI-D input connector (digital RGB)
x Connect a computer equipped with an HD15
output connector (analog RGB)
Using the supplied HD15-HD15 video signal cable (analog RGB),
connect the computer to the monitor’s HD15 input connector (analog
RGB).
screw positions of
VESA compatible
stand
75 mm
× 75 mm
to the computer’s DVI output
connector (digital RGB)
DVI-D video signal
cable (digital RGB)
(supplied)
to the DVI-D input
connector
(digital RGB)
to the computer’s HD15 output
connector (analog RGB)
HD15-HD15 video signal
cable (analog RGB)
(supplied)
to the HD 15
input connector
(analog RGB)