Sony SDM-E76D - Manual (Page 34)

10
(GB)
x Using the MENU, m/M, and OK buttons
1 Display the main menu.
Press the MENU button to display the main menu on your
screen.
2 Select the menu you want to adjust.
Press the
m/M buttons to display the desired menu. Press the
OK button to select the menu item.
3 Adjust the menu.
Press the
m/M buttons to make the adjustment, then press the
OK button.
When you press the OK button, the setting is stored, then the
display returns to the previous menu.
4 Close the menu.
Press the MENU button once to return to normal viewing. If
no buttons are pressed, the menu closes automatically after
about 45 seconds.
x Resetting the adjustments
You can reset the adjustments using the RESET menu. See
page 14 for more information on resetting the adjustments.
x Controlling the monitor by computer
Press the MENU button down for at least 5 seconds. You will see
an on-screen message indicating the current setting. After 3
seconds the DDC/CI setting is switched on or off, as shown
below.
Note
This function applies only to computers that support the DDC/CI
(Display Data Channel Command Interface) function.
Adjusting the backlight
(BACKLIGHT)
If the screen is too bright, adjust the backlight and make the screen
easier to see.
1 Press the MENU button.
The main menu appears on the screen.
2 Press the m/M buttons to select (BACKLIGHT)
and press the OK button.
The BACKLIGHT menu appears on the screen.
3 Press the m/M buttons to adjust the light level and
press the OK button.
Adjusting the contrast
(CONTRAST)
Adjust the picture contrast.
Note
While COLOR is set to sRGB, you cannot adjust CONTRAST,
BRIGHTNESS or GAMMA.
1 Press the MENU button.
The main menu appears on the screen.
2 Press the m/M buttons to select 6 (CONTRAST) and
press the OK button.
The CONTRAST menu appears on the screen.
3 Press the m/M buttons to adjust the contrast and
press the OK button.
qa Other menus (page 14)
Set the following menu
items.
• RESET 0
• MENU LOCK
1 2 8 0 1 0 2 4 6 0 H z x /
E X I T
O K
C A N C E L
R E S E T
MENU
OK / INPUT
,
,
OK / INPUT
MENU
On-screen messages
(Appear for a while)
DDC-CI : ON
(default setting) Allows the computer to control
menu settings.
DDC-CI : OFF Does not allow the computer to
control menu settings.