Sony SDM-E76D - Manual (Page 41)

17
(GB)
Troubleshooting
Before contacting technical support, refer to this section.
On-screen messages
If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see “Trouble symptoms and remedies” on page 18.
If OUT OF RANGE appears on the screen
This indicates that the input signal is not supported by the
monitor’s specifications. Check the following items.
If “xxx.x kHz/xxx Hz” is displayed
This indicates that either the horizontal or vertical frequency
is not supported by the monitor’s specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
If “RESOLUTION > 1280 × 1024” is displayed
This indicates that the resolution is not supported by the
monitor’s specifications (1280
× 1024 or less).
If NO INPUT SIGNAL appears on the screen
This indicates that no signal is being input.
GO TO POWER SAVE
The monitor will enter the power saving mode after about 5
seconds from the time the message is displayed.
If CABLE DISCONNECTED appears on the screen
This indicates that the video signal cable has been disconnected.
GO TO POWER SAVE
The monitor will enter the power saving mode after about 45
seconds from the time the message is displayed.
OUT OF RANGE
I NPUT 1 : DV I – D
x x x . x k H z / x x x H z
I NFORMA T I ON
Example
Example
I NFORMA T I ON
NO I NPUT S I GNA L
GO TO POWER SAVE
I NPUT 1 : DV I – D
Example
CAB L E D I SCONNECT ED
I NFORMA T I ON
I NPUT 1 : DV I – D
GO TO POWER SAVE