Sony DCR-HC20 - Manual (Page 77)

Troubl
esho
otin
g
Troubleshooting 77
Digital program editing does not
function. cSet the input selector on the VCR correctly, then check the connection
between your camcorder and the VCR. (p. 62)
cWhen your camcorder is connected to a DV device that is not a Sony
product via an i.LINK cable, select [IR] in step 9 of “Step 1: Preparing
your camcorder and VCR for operation” (p. 64).
cAdjust the synchronization of the VCR. (p. 66)
cEnter a correct [IR SETUP] code. (p. 65)
cSelect the mode used to cancel recording pause again. (p. 65)
cSet your camcorder and the VCR more than 30 cm (12 in.) apart. (p. 65)
• The program may not be set to a blank section on the tape.
The VCR is not responding properly
during Digital program editing when
it is connected via an i.LINK cable. • While connecting via an i.LINK cable, select [IR] in step 9 of “Step 1:
Preparing your camcorder and VCR for operation” (p. 64).
Symptom Cause and/or Corrective Actions