Sony DCR-HC20 - Manual (Page 83)

A
ddi
tio
nal
In
for
m
a
tio
n
Additional Information 83
When labeling the cassette
Be sure to place the label only on the locations
as shown in the following illustration so as not
to cause malfunction of your camcorder.
After using the cassette
Rewind the tape to the beginning to avoid
distortion of the picture or the sound. The
cassette should then be put in its case, and stored
in an upright position.
When the Cassette Memory function
does not work
Re-insert the cassette. Cassette Memory may
not work when the gold-plated connector is
dirty or dusty.
When cleaning the gold-plated
connector
Generally, clean the gold-plated connector on a
cassette with a cotton-wool swab after every 10
times it has been ejected.
If the gold-plated connector on the cassette is
dirty or dusty, the remaining tape indicator may
not be indicated correctly, and you may not be
able to operate functions using Cassette
Memory.
About the
“InfoLITHIUM”
battery pack
This unit is compatible with the
“InfoLITHIUM” battery pack (P series). Your
camcorder operates only with the
“InfoLITHIUM” battery pack.
“InfoLITHIUM” P series battery packs have the
mark.
What is the “InfoLITHIUM” battery
pack?
The “InfoLITHIUM” battery pack is a lithium-
ion battery pack that has functions for
communicating information related to operating
conditions between your camcorder and an
optional AC Adaptor/charger.
The “InfoLITHIUM” battery pack calculates
the power consumption according to the
operating conditions of your camcorder, and
displays the remaining battery time in minutes.
With an AC Adaptor/charger (optional), the
remaining battery time and charging time
appear.
To charge the battery pack
• Be sure to charge the battery pack before you
start using your camcorder.
• We recommend charging the battery pack in
an ambient temperature of between 10°C to
30°C (50°F to 86°F) until the CHG (charge)
lamp turns off. If you charge the battery pack
outside of this temperature range, you may not
be able to charge it efficiently.
• After charging is complete, either disconnect
the cable from the DC IN jack on your
camcorder or remove the battery pack.
Do not put a label
along this border.
Labeling position
Gold-plated
connector
, continued