Alpine CVA-1004 - Manual (Page 28)

26
-EN
Other Useful Features
Setting the Bass Control
You can change the Bass Frequency emphasis to
create your own tonal preference.
1
When the monitor is open, press bass engine.
BASS ENGINE mode is displayed in the monitor.
2
Press preset 1 to select the desired mode.
3
Press g or f to adjust the selected mode.
• Bass Level : -7~+7
You can emphasize or weaken the bass
frequency.
• Bass center frequency :
→ 60Hz ↔ 70Hz ↔ 80Hz ↔ 90Hz ↔ 100Hz ↔ 130Hz ↔ 150Hz ↔ 200Hz ←
Emphasizes the displayed Bass frequency
ranges.
• Bass Band Width (Q-Factor):
→ WIDE1 ↔ WIDE2 ↔ WIDE3 ↔ WIDE4 ←
(Narrow) ←..............................→ (Wide)
Changes the displayed frequency's band width
to wide or narrow.
4
Press bass engine to return to normal mode.
NOTES
• If no buttons are pressed within 10 seconds, the Bass
control setting will be turned off automatically.
• Depending on the type of external audio processors
connected to the unit, you may not be able to set some
settings.
• The settings of the Bass will be individually
memorized for each source (FM, AM and CD) until
the setting is changed. Depending on the connected
devices, some functions and display indications do not
work.
Erasing Disc Title/Station Title
1
When the monitor is open, press
TITLE
to select the titling mode. Then, press
and hold TITLE for at least 2 seconds.
2
Within 10 seconds, press and hold -/J for at
least 2 seconds to activate the title scanning
mode.
The title in the display will blink.
3
Press g or f repeatedly until the title you
want to erase is displayed.
4
Press -/J to display “DELETE TITLE.”
Press -/J again within 10 seconds to erase the
selected title.
5
Press TITLE to cancel the title erasing mode.
NOTES
• You cannot erase CD-TEXT.
• When no title is input, “NO DATA” is displayed and
then the unit returns to the disc/station titling mode.
TITLE bass engine
g g g g g f f f f f
Preset 2
: : : : :/J J J J J
Preset 1
g g g g g f f f f f : : : : :/J J J J J
bass engine TITLE Preset 2 Preset 1