Alpine CVA-1004 - Manual (Page 41)

39
-EN
Simultaneous Operation
You can watch the video portion of another source
while listening to current source.
After carrying out steps 1 to 3 of "To display the
SETUP screen" (page 29), perform the operation
shown below.
1
Press V.SEL to select the video position.
Example of when not connecting the expansion
box:
(Picture) RADIO ∗1 AUX ∗2 NAV.
(Voice) RADIO RADIO RADIO
Example 1 of when connecting the expansion
box (KCE-104V):
(Picture) RADIO ∗1 AUX1 ∗2 AUX2 AUX3 ∗3
(Voice) RADIO RADIO RADIO RADIO
SPE.ANA ∗4 NAV.
RADIO RADIO
Example 2 of when connecting the expansion
box (KCE-104V):
(Picture) DVD DVD ∗5 AUX2
(Voice) DVD DVD DVD
SPE.ANA ∗4 NAV. AUX3 ∗3
DVD DVD DVD
∗
1 The source, band, frequencies, etc., are
displayed.
∗
2 If a DVD player or DVD changer is connected,
you can receive the DVD picture/sound.
DVD player (DVA-5200) is connected:
Press FUNC on the remote control supplied
with the DVD player. The DVD picture and
sound are output.
DVD player (DVA-5205) or DVD changer (DHA-
S680) is connected:
Press and hold V. OUT on the remote control
supplied with the DVD player or DVD changer
for at least 2 seconds. The DVD picture and
voice are output.
∗
3 When the KCE-104V and a rear camera are
connected, the unit can receive the picture
(refer to “Setting the External Input” on page
37).
→ → →
← ← ←
Other Useful Features
→ → →
← ←
→ → → →
∗
4 Set SPE.ANA to ON to select the SPE.ANA
display (refer to “Displaying Spectrum
Analyzer” on page 38).
Press TITLE
to select the desired SPE.ANA
mode from 1 through 6 and SCAN.
∗
5 The source, disc number, elapsed time, etc.,
are displayed.
NOTES
• When AUX IN (AUX1, AUX2, AUX3) and NAV.IN are
set to ON, the AUX (AUX1, AUX2, AUX3) and NAV.
mode is displayed (refer to "Setting the External
Input" on page 37).
• To switch the sound source, press SOURCE/PWR
during SIMUL. If the picture and the sound are from
the same source, the SIMUL function is not canceled.
2
Press and hold V.SEL for at least 2 seconds to
cancel the SIMUL function.