Alpine CVA-1004 - Manual (Page 38)

36
-EN
Rear Monitor Setting
The optional expansion box (KCE-104V) must be
connected. If AUX/NAV. is turned ON (as shown in
“Setting the External Input” on page 37), and a
rear-seat monitor and navigation system are
connected to the CVA-1004, the picture/sound for
the rear-seat monitor can be selected from the
CVA-1004.
There are two ways to set the Rear Monitor:
• by pressing R. SEL (short cut)
• by the SETUP screen
After carrying out steps 1 to 3 of "To display the
SETUP screen" (page 29), perform the operation
shown below.
Setting by R. SEL
1
When the monitor is open, press and hold
CHG/R.SEL for at least 2 seconds, or press
REAR ON on the optional Remote Control.
.
2
Press CHG/R.SEL to select MONITOR-1 OUT or
MONITOR-2 OUT.
Other Useful Features
3
Press g or f to select the mode to display
on the rear monitor.
AUX-1/AUX-2/AUX-3
∗
:
The picture/sound of the device connected to
Terminal AUX will be played on the rear-seat
monitor.
∗ AUX NAME set in the “Setting the External Input”
(page 37) will be displayed.
NAV. :
The navigation screen will be displayed on the
rear-seat monitor and the voice guidance will
be produced if the navigation system is
connected.
SPE.ANA :
The SPE.ANA image is displayed when set to
ON in “Displaying Spectrum Analyzer”(page
38).
OFF :
AUX OUT mode is canceled.
4
After setting is completed, press and hold
CHG/R.SEL for at least 2 seconds to return to
normal mode.
Setting by the SETUP screen
1
When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2
Press preset 3 to activate the AUX setting mode.
Press preset 3 again to select MONITOR-1
OUT/MONITOR-2 OUT.
3
Press g or f to select the mode to display
on the rear monitor.
For any other settings, press preset 3 or another
preset button.
4
After setting is completed, press MUTE/SETUP
to return to normal mode.
NOTE
If a DVD player or DVD changer is connected to the
AUX 1, AUX 2 or AUX 3 terminal, the DVD picture
appears by performing steps 1 and 2 of "Simultaneous
Operation" on page 39. Then, perform steps 1 to 4 on
this page so the DVD picture and sound are output.
g g g g g f f f f f
Preset 3
MUTE/SETUP
CHG/R.SEL
Preset 5
TITLE