Alpine IVA-D105 - Manual (Page 37)

35
-EN
+01GB05IVAD105.fm
ALPINE IVA-D105 68-08564Z59-A (EN)
General Setup Operation
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [ ] of GENERAL SETUP.
The GENERAL setup screen appears.
3
Touch [ ] or [ ], etc., of the desired item to change
its setting.
Setting items:
CLOCK / CLOCK ADJUST / DAYLIGHT SAVING TIME /
DEMONSTRATION / BEEP / AUTO SCROLL / LANGUAGE
SELECT / LED DIMMER LEVEL
4
Touch [RETURN] to return to the previous screen.
• Immediately after changing the settings of General Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF.
Otherwise, the settings may not be changed.
The clock indication on the monitor display is turned on or off
respectively.
Setting item: CLOCK
Setting content: OFF / ON
Setting item: CLOCK ADJUST
Further setting items : HOUR / MINUTE / TIME ADJUST
Setting content: 1-12 / 0-59 / RESET
• The clock-adjusting mode is canceled when the power is turned off,
when [RETURN] is touched.
Setting item: DAYLIGHT SAVING TIME
Setting content: OFF / ON
This unit is equipped with a demonstration function capable of showing
basic operations of respective sources on the monitor display.
Setting item: DEMONSTRATION
Setting content: OFF / ON
• The demonstration operation is automatically repeated until the
function is turned off.
Setting item: BEEP
Setting content: OFF / ON
• A beep always sounds when opening or closing the monitor,
regardless of this setting.
GENERAL Setup
To display the General mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the General mode operation has
been released. Engaging the parking brake can reactivate the
General mode, as long as the car's ignition has not been turned
off. It is not necessary to repeat the above procedure (1 through
3), of “To display the General mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the General mode screen.”
The following steps 1 to 4 are common operations to each
“Setting item” of GENERAL Setup. Refer to each section for
details.
Displaying the Time
Setting the Time
HOUR: Adjust the hour.
MINUTE: Adjust the minute.
RESET: If the clock shows less than 30 minutes past, the
minute will be “0”; more than 30, the hour advances.
Setting Daylight Saving Time
ON: Place the Summer Time mode ON. The time advances by
one hour.
OFF: Return to the ordinary time.
Demonstration Function
ON: Turns on the demonstration mode to show the basic
operations.
OFF: Turns off the demonstration mode.
Sound (Beep) Guide Function
ON: Activate the Sound Guide mode.
OFF: Deactivate the Sound Guide mode. The sound guide
beep will not be produced when a button on the unit is
pressed.
+01GB00IVAD105.book Page 35 Monday, January 15, 2007 4:02 AM