Panasonic BL-MS103A - Manual (Page 145)

15 Error Messages
[For assistance, please call: 1-800-272-7033] 145
SD Memory Card Error Messages
Error Message Causes and Solutions
Sequential Display mode
is active.
Set mode switch on back
of unit to [NORMAL], then
turn unit off/on. This error is displayed when the remote control is
used during Automatic Display Mode.
• Set the mode switch on the back of the device
to Normal and turn the power on again.
Error Message Causes and Solutions
SD Memory Card is
locked.
Unlock the SD Memory
Card and try again. This error is displayed when an SD memory
card's write-protection is on.
• Turn the write-protection off.
No SD Memory Card.
Insert card and try again. This error appears if an SD memory card has not
been inserted.
• Insert an SD memory card.
SD Memory Card is full. This error is displayed if there is no free space on
the SD memory card.
• Insert a blank SD memory card, or erase
unneeded data from it.
Cannot use this SD
Memory Card. This error appears when an SD memory card not
recognized by the BL-WV10A is used.
• Use a recognizable SD memory card or
format it using the BL-WV10A (see
page 120).
Could not format. This error appeals when memory card formatting
fails.
• Re-format the card. If that fails to correct the
problem, use a different SD memory card.