7 command line interface use and guidance, Cli command conventions, 7 command line interface use and guidance – ATTO Technology 3400 User Manual
Page 18
13 ATTO FibreCenter 3400
Ins
tallation and Operation Manual
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8
B
E
G
F
D
C
A
Zone 1
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8
B
C
A
Zone 2
Zone 3
B
C
A
7 Command Line Interface use and guidance
You will be able to perform all configuration via the Telnet interface through the Ethernet port using
Command Line Interface (CLI) commands.
To configure the ATTO FibreCenter you will
access the Command Line Interface (CLI), a set of
ASCII commands, through a Telnet session.
Except for the Get Switch command return, ports
are labeled 1 through 8: all connections are
assumed to be between port 1 and 2 | 3 | 4 | 5 | 6 |
7 | 8 in zone 1, between port 1 and 2 | 3 | 4 in zone
2 and between port 5 and 6 | 7 | 8 in zone 3. In the
Get Switch command return, ports are labeled
with letters.
CLI command conventions
❈CLI commands are case insensitive: you may
type all upper or all lower case or a mixture.
Upper and lower case in this manual and the
help screen are for clarification only.
❈Responses to commands are specified in the
Results field for each command, followed by
the Telnet prompt $ .
❈Symbols, typefaces and abbreviations used to
indicate functions and elements of the
command line interface used in this manual
include those found in Exhibit 7-3.
❈The settings resident in the FibreCenter 3400
will be preserved over a power-off, power-on
cycle and restored automatically on power-
on.