ATTO Technology 3400 - Manual (Page 20)

15 ATTO FibreCenter 3400 Ins tallation and Operation Manual
7.1 Ethernet and Telnet configuration commands
Configure the ATTO FibreCenter 3400 using a Telnet session over the Ethernet port. The commands in
this section configure or provide information about the Ethernet port and the Telnet session.
Default Router
Sets a new default router address for the Telnet server. Set the default router within the subnet as defined by the subnet mask and IP Address.
Limit: 0-255 Default: 0.0.0.0
Action: set•RACK •000•Default•Router•[n.n.n.n] Information: get•RACK •000•Default•Router
reset•rack•000 or power cycle
Echo
Sets the Telnet command echo mode.
Limits: [on|off]
Action: set•RACK •000•Echo•[on|off] Information: get•RACK •000•Echo
reset•rack•000 or power cycle
Factory Defaults
The Telnet parameters are set to their factory default values.
Action: set•RACK •000•Factory•Defaults Information: none
reset•rack•000 or power cycle
Idle Timeout
Sets time period in seconds after which, if there is no action on the Telnet port, the Telnet session is shut down.
Default: 60 minutes
Action: set•RACK •000•Idle•Timeout•[n] Information: get•RACK •000•Idle•Timeout•[n]
reset•rack•000 or power cycle
IP Address
Sets a new IP address which will be used after next reset.
Limit: 0-255 Default: 192.168.1.1
Action: set•RACK •000•IP•address•[n.n.n.n] Information: get•RACK •000• IP•Address
reset•rack•000 or power cycle
Security Traps
Sets the Telnet security level
Default: 3
Action: set•Security•Traps•[n] Information: get•RACK •000•Security•Traps
reset•rack•000 or power cycle
Subnet Mask
Sets a new subnet mask which will be used after next reset.
Limit: 0-255 Default: 255.255.255.0
Action: set•RACK •000•Subnet•Mask•[n.n.n.n] Information: get•RACK •000•Subnet•Mask
reset•rack•000 or power cycle
Telnet
Ends the current Telnet session and opens another
Action: Telnet Information: none
Telnet Status
Returns the Telnet status. The format will be determined in the future.