Panasonic FS-100 - Manual (Page 62)

FS-100 Functions
FS-100 Portable DTE Recorder
44
10. Reel Display
In
Record
or
Playback
modes, this item displays the
particular REEL that a clip is located in or, has been marked
to. If in
PLAY FROM
>
REEL LIST
mode, the REEL appears in
brackets for example, [REEL]. This area is blank if
NO REEL
has been selected.
11. DISP
information field that displays data type.
12. DISP
information field that displays current data.
DISP (display) Information Fields
Use the
DISP
function button to display current operation
information fields 11 and 12. The data shown depends on the
mode of operation, i.e.
DVCPROHD
,
DVCPRO50
,
DVCPRO/DV
.
Pressing the
DISP
button advances the display to the next
category of information. Below is a table of the data types and
data available with
DISP
.
Field
Number Data Type /
Data Description
11 COUNTER
12 Shows frame count of current video clip during record or
playback.
11 REMAINING
12 Record: counts down number of available frames
remaining, as time, on a specific disk.
Playback: displays time remaining of the current clip.
11 DV (NTSC or PAL) or HD (see note following table)
12 Record: displays the external timecode value being
generated by a camcorder or other device during a
recording session. Timecode mode must be set to EXT TC
for this function to operate, refer to TIME CODE EXT, REC
RUN, FREE RUN, REGEN on page 61.
Playback: displays the embedded DV timecode value in a
particular track.
11 UB NTSC
12 Displays the set user bit value in a particular clip. A user
bit value must be added for this to display, refer to UB SET
on page 63.
11 ABSOLUTE