Merrychef eikon e5 - Manual (Page 20)

20 Service & Parts Manual original Instructions
Part Number 32Z3814 US
Issue 1
PR
ODUC
T
DE
TAILS
J
K
L
M
USB oven programs (J) 9.8
IMPORTANT: Downloading from a USB will clear
all the existing programs.
Check that the key has the correct number/code
for the programs you want to load into the oven
memory.
Select USB from the settings screen. 9.8.1
Slide the USB cover (logo on the oven front) 9.8.2
upwards to insert the USB into the slot.
When the inserted USB stick has finished 9.8.3
flashing, select the required USB symbol, for example;
RECIPES.
Select the new file using the scroll arrows if 9.8.4
required to locate the file. Note; a tinted band over a
file name indicates the file is not available to use.
Double check the file is correct before selecting 9.8.5
OK, if not, select ‘X’ and locate the correct file.
Progress of the file update is displayed. Once 9.8.6
completed the oven restarts and commences heating
up to the PREHEAT temperature ready to cook.
Remove the USB and keep in a safe place. 9.8.7
Reposition the USB cover.
Restore Factory Defaults (k) 9.9
Select the factory symbol to replace the existing 9.9.1
oven settings with the original factory default settings.
Note; this action cannot be undone.
Select OK, or select the red cross to cancel and 9.9.2
keep the existing settings.
Temperature Band (L) 9.10
Select the ‘Temp Band’ symbol at which the 9.10.1
oven controls i.e. ±10°C.
Select the required temperature band 9.10.2
checkbox, shown by a green tick. Note; although the
lowest practical Temp Band should be used, if the
set oven temperature falls by more than the selected
Temp Band, the ready to cook mode and Temp Band
are deactivated until the oven reaches the preheat
temperature.
Change Password (M) 9.11
Select the key symbol to change the oven 9.11.1
passwords.
Select the oven Settings or Service symbol. 9.11.2
Enter the existing password and select OK to 9.11.3
confirm.
Enter the new password, select OK. 9.11.4
Confirm new password, select OK. 9.11.5