Power Soak 33529 Skewer Wash Owner's Manual - Manual (Page 12)

8
Control Buttons and Lights
Green Button
The green button starts the water circulation in the wash sink. The
rotation of the skewer rack is caused by the water circulation pushing on
the skewers in the rack. If the rack is not fully loaded, it may not rotate.
If the water circulation does not start, refer to trouble shooting section.
Red Button
The red button stops the water circulation. The rotation of the skewer
rack will stop when the water circulation stops.
Green Light
Slow Flashing – “POWER ON” – The Power Soak system is ready for
filling.
Solid Illumination
– “RUNNING” – wash sink is full of water and the
system is running. (The light will not become solid until after start
button is pushed.)
Blue Light
Solid Illumination – “CHANGE WASH WATER” – four hours after the
start button is pushed, the blue light will illuminate indicating that the
wash sink must be completely drained and refilled.
Red Light
Slow Flashing – “FILL THE SANITIZER TANK”
Solid Illumination – “CHANGE THE SANITIZER SOLUTION” – after two
hours, the sanitizer sink must be completely drained and refilled.