Power Soak 33529 Skewer Wash Owner's Manual - Manual (Page 21)

17
Control Panel Lights and Buttons
Status Lights on Control Panel
The lights on the control panel will indicate the status for operation of
the Skewer Wash. The wash pump will be automatically stopped by
several features of the control system.
Green Light
(under the green “Start” button)
Slow Flashing
– “POWER ON” – Indicates the electrical system is
energized and ready to have the wash and sanitize sinks filled. The
upper sensor does not sense a water level high enough to start the
machine.
Solid Illumination
– “OPERATING” – Indicates that the wash sink is full
and the START button has been pressed. The UPM program will
continue operating (solid illumination of the green light) when the STOP
button is pressed and the wash pump motor has stopped. The green
light will return to flashing when the wash tank is drained.
Blue Light
(between the green “Start” and red “Stop” buttons)
The blue light is not used for normal operation. It is only used during
service procedures.
Red Light
(under the red “Stop” button)
Slow Flashing – “FILL SANITIZER TANK” – When the wash tank is
filled with water, the red light will blink indicating the sanitizer tank must
be filled to the water line. It will turn off when the sanitizer tank is full.
Solid Illumination
– “CHANGE SANITIZE SOLUTION” – Two hours after
the tank is filled to the top level sensor, the red light will illuminate
indicating that it is time to change the sanitizing solution.