Power Soak 33638 SILVERWARE WASHER OWNER'S MANUAL - Manual (Page 12)

12
For detailed instructions about installation, refer to the
Silverware Pre-washing System INSTALLATION
manual that ships with the unit.
Electrical Power Requirements
The electrical power requirements of your new system are
shown on the Power Soak serial number plate located as
follows:
• Mobile and free-standing stationary models—On
the side of the control enclosure which is attached
to the motor
• Built-in models—On the side of the wash tank
Electrical Wiring Requirements
The wiring required for your system depends on the type
of system you have purchased:
• Mobile 115V units come equipped with a power
cord and may be plugged into any approved outlet
rated for the amperage requirement stated on the
Power Soak serial number plate.
• Mobile 208V 1PH and 460V 3PH units must be
connected to a wall-mounted junction box, outlet, or
disconnect by a licensed electrician. The wall-
mounted device must be NEMA 4X or IP67 rated
and must be supplied by a dedicated circuit.
• Free-standing stationary units must be connected to
a wall-mounted junction box or disconnect using
water-tight flexible conduit by a licensed electrician.
The wall-mounted device must be NEMA 4X or
IP67 rated and must be supplied by a dedicated
circuit.